Maytag Atlantis Washer Manual Remove Agitator From Maytag
Turn off the water and remove inlet hoses from the washer. What are the common troubleshooting techniques for a Maytag. The manual for a Maytag Wringer Washer? Powergold 12 Keygen Software on this page. Washer Repair- Replacing the Drive Belt (Whirlpool Part # 2. Click here for more information on this part, installation instructions and more. This particular Drive Belt is specific to Whirlpool manufactured brands including Admiral, Estate, Inglis, Kenmore, Kitchen. Aid, Roper, Maytag, Crosley, Jenn- Air,.
• 1 Answer SOURCE: I have had the same problem and found that the teeth on the under side of the agitator had been worn down to nothing. I assume this is from years of over loading (not from me) and so the agitator could not spin any more. I would tighten the bolt that holds th agitator on and it would come loose after a few loads. So my solution was to get a little bit longer bolt and newer plastic washer and tighten it as tight as i could and it seemed to work.
Versus buying a new agitator base that would cost about $20-$30 and would have to wait for the part to be ordered. Hope this helps Posted on Oct 23, 2007. • 5911 Answers SOURCE: If this is a Maytag Performa or Atlantis model all you have to do is remove the center cap on the agitator by pulling on it and locate the agitator bolt underneath. Loosen the bolt, and the agitator should pull straight up.
If this is a Maytag Dependable Care series there will be 1/4 inch screw along the side of the agitator towards the bottom. Aahatein Mtv Splitsvilla 4 Theme Song Mp3 Free Download more. Remove this screw and the agitator will pull straight up. Download Free Super Eurobeat 170 Rare on this page. I hope this helps you. PS If the problem is due to the build up of fabric softener, soak in some hot water to loosen it up.